Virago Single Carb Manifold XV700-XV1100 & MIKUNI VM30 carburetor + Filter

Description

PLEASE READ ENTIRE DESCRIPTION BEFORE YOU BUY!
Please buy responsibly. Cheaters, cheep scatters, beginners or game players are not welcome! THIS IS MANDATORY! IF YOU HAVE NO IDEA WHAT YOU ARE DOING JUST SIMPLY DON'T BUY IT!!! THANKS A LOT...
NEW REDESIGNED MANIFOLD TO OPTIMIZE MIXTURE FLOW.
Hello, Manifold and carburetor are shipped separately. 99% of the time they might arrive on different days. Please check your note or messages for additional tracking updates. Best regards.
If you are unsure how to install the manifold and or carb after reading an Installation Guide, please take your  part(s) to a licensed or certified mechanic for install. I cannot be held responsible for damaged product due to buyers lack of knowledge.
I do not accept returns due to buyers remorse, lack of understanding how to install, product damaged during installation or incorrect product purchased for your particular bike. If you have any questions, please contact.
No beginners or game players please. I m working hard to make you old timers get back on the road. Your cooperation would be appreciated. Thank you for understanding.
NOTE: Engine tuning should only be performed by experienced mechanics as a "too-lean" condition can melt pistons and a "too-rich" condition can lead to excessive component wear and failure. Always do frequent plug checks or O2 measurements when making any carb adjustment.
All items are shipped via FedEx of DHL Express international service, so it is guaranteed safe and on time delivery.
Listing price includes an expedited shipping via FedEx, so it is fast as it can be. Usually it takes from 3 to 9 business days worldwide (for manifold). Carburetor might arrive a few days later than manifold.
ALUMINUM bolt-on single carburetor manifold with Genuine Mikuni VM30 carburetor and carburetor holder/boot.
Manifold is designed to fit all Yamaha Virago XV700, 750, 920, 1000, 1100.
Good to know!
https://www.youtube.com/watch?v=vmltHKxtQaw&t=27s
Manifold and carburetor will ship separately. 99% of the time they might arrive on different days. Usually carburetor will arrive sooner than manifold if you are located in the USA.
NOTE! Carburetors are coming with default factory jetting of main jet No.250.
Air filter is 60 mm air throat, with laser engraved Viking Gorilla stainless steel face.
For each application carburetors must be re jetted depending on specific engine size. Please feel free to ask about jetting requirements for your application. Thank you.
For the VM 30 MM Mikuni round slides:
For the 700/750 cc bikes.  so for single carb the jetting recommended is.
Pilot jet 25 with main jet 155.
Needle 6DH3 center notch on the circlip.
Needle jet a 159 series, P-6.
Air jet leave stock in place.  not necessary to remove.  if a rich issue then remove.
*
For the 920/1100 cc bikes.  So for single carb the jetting recommended is.
Pilot jet 25 with main jet 195.
Needle 6DH3 center notch on the circlip.
Needle jet is 159 series, P-6.
Air jet leave stock in place.  not necessary to remove.  if a rich issue then remove.
WARNING! DO NOT INSTALL THE MANIFOLD WITHOUT GASKETS TO PREVENT DEFORMATION OF THE FLANGES. THIS IS MANDATORY!
Throttle cable can be easy modified, please look at the picture.
Materials:
ALUMINUM
Parts Included:
Manifold
2 x gaskets
1 x Carburetor Mikuni VM30
1 x steel clamp
1x Air filter